Telephone
08 205 86 93
Select language
SI | EN | DE

Mold - Flow analysis

(Injection molding simulation)

To foresee any inadequate and potentially costly decision made in development of injection molding component or tool development we are very often using Mold-Flow analysis based on part design and flow characteristics of particular polymer material.

The analysis results can provide information about the suitability of particular product/ tool design and plastic material combination and pointing on area of potential unwanted defects such as short shots, sink marks or welding lines, all that is much easier and cheaper to avoid before cutting the steel in mold.

We can make a simulation of filling by injection molding of plastic material, on the basis which we can anticipate when the production will be field with plastic melt. Calculation is based on the knowledge of geometry, location of injection point, the type of material and conditions of the injection molding process.
T MAPMFslika1